Skip to Content
avatar image
Former Member

QALS not updating SLED,NEXT inspection date

Hello all,

When I execute the QA32 report, I chose the SLED,Next inspection date and manf date from the layout to display the fields. But the date does not updated in the column and its blank. so I checked in QALS table and it was blank too. So I wrote a query to combine batch table (MCHA) and QALS and still it's not retrieving the date. But the entries were in there in batch master MSC3N.

Please advise how to pull these information without development if possible.

Regards,

Prakash

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Aug 25, 2017 at 08:52 PM

    It depends on what batch level you are at.

    Those fields are in either MCH1, MCHA.

    Try the MCH1 table instead.

    I'm not sure what fields you are selecting in QA32 but the three fields you mentioned are not available in that transaction normally.

    Have you made enhancements or modifications to QA32?

    Add comment
    10|10000 characters needed characters exceeded