Skip to Content
Former Member
Aug 31, 2007 at 03:55 AM

Access Sequence Problem!


Dear All,

I have a condition type <b>"ZPAR"</b> and the Access sequence attached to this is <b>"K304" (Material with Release).</b>

The client had a new requirement so I created a new condition table and assigned the table to a new Access Sequence <b>"ZLAN"</b> to the condition type.

In this case I didn't create any new condition record.

But later these requirements were not required so I changed the Access sequence back to <b>"K304" (Material with Release) .</b>

After I change it I am getting an error when I create a Sales Order.

The error <b>"Strategy group has not been maintained"</b> & <b>" Message no. 6P031"</b>

I went through the message but and checked the Material master but it was not helpful.

Then I created a new material master and created a Sales Order the error didn't pop up.

I further went ahead and created a condition record "ZPAR" with this material and created a sales order. The message popped up this time. Confirming the error was because of changing the access sequence in the.

This seems to be quite strange!

Can you please suggest a solution.

Thanks & Regards,

Subodh Kumar