PM and PP integration

[Former Member]

Dear Experts

I am trying to integrate PM and PP.

>> step 1: I have created a task list and have set system condition '0' in the header data.

>> step 2: Created an equipment and assigned the work center (PP) in the location TAB.

>> step 3: Created a plan with the same equipment (created in step 2) and attached the the task list (created in step 1).

>> Scheduled the plan.

Now the ISSUE is that when the orders are released they don't show system condition as zero in the orders, and as a result there is no impact on capacity (checked via tcode cm50). I have to the system condition '0' manually in each order.

QUESTION: Is there a way I can get system condition '0' in all the orders. Note the I have already set the system condition as zero in task list.....

Pl help !!

Regards

Rubab Hasan

[MTerence]

Hi Ruhab,

Refer below thread

https://archive.sap.com/discussions/thread/3791371

Regards

Terence

[Former Member]

Hi Terence

You are suggesting to raise a note here? No IMG settings can help here?

Regards

Rubab Hasan

[Former Member]

Also I m getting system condition as '0' on the Work Order operation level but it is not putting any impact on the capacity. However, the system condition on Work Order header is not zero, as a result the capacity is not locked in cm50 tcode

[MTerence]

Hi Rubab,

Your initial question says the system condition is not copying to orders. In such case, you need to apply the note. If it is getting copied, we need to see what is the issue.

Have you checked the "Reservation by PM" check box in config for the system condition.

Regards

Terence