Skip to Content
avatar image
Former Member

Variant Configurator

I am configuring materials using one configurable material with a Base UM of SY. I need to be able to convert this UM to LB or LY, etc in a Quote Document for costing in the unit of measure. Adding to the complexity I have certain characteristic values that do not allow me to use the Units of Measure to set conversion in the Basic Data of the Material Master.

Examples are:

SLIT_ROLLS is my config mat.

MAT_TYPEB is my material type

MAT_THICKNESSB is my material thickness

Certain combinations of MAT_TYPEB & MAT_THICKNESSB have different conversion rates of SY to LB

MAT_TYPEB MAT_THICKNESS CONV. RATE

NMX410 .005 4.77 SY/LB

NMX410 .007 3.16 SY/LB

NMX411 .010 6.61 SY/LB

Please help.

Thanks

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Aug 22, 2007 at 05:29 PM

    The characteristic-value calculaiton and conversion is one issue: this you'll have to write a Function Module (look up Procedures Variant functions)

    Probably your bigger problem is the material master / Sales unit of measure conversion, that I can't provide an answer for with the level of detail provided, and would have to play around with a lof of IMG config to figure that on out

    Bill

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 22, 2007 at 05:45 PM

    One cannot change the UM until n unless stock is zero and to change in condition of zero it is better to change sales unit of measure only or u can set conversion formula for UM. For eg. One set = 50 pcs.

    Pls gv points if helpful.

    regards

    Ajit Singh

    Add comment
    10|10000 characters needed characters exceeded