Skip to Content
avatar image
Former Member

USEREXIT_NUMBER_RANGE

Hi,

I need to use the UserExit for setting the internal Number Ranges for the Invoice for different Sales Organisations.

For that I am using USEREXIT_NUMBER_RANGE in the Program RV60AFZZ.

I also got the access key for the same.

When i am trying to change the program, I am getting the following message

"<b>Carry out modification comparison for REPS RV60AFZZ first. No changes possible</b>" and "<b>Run the modification comparison (SPAU) for the object.

If the object is supported by the Modification Assistant, you can compare/adjust it by clicking the stoplight.

If the object was not changed using the Modification Assistant, but by inclusion of notes using the Note Assistant, the respective notes must be compared/adjusted. If it is not absolutely clear which note caused the object to be changed, you can use the Modification Browser SE95 to perform a search: Expand the subtree "Note Corrections" and then use the search function to search for the object name."</b>

Can someone help me with this please??

Thanks,

Shashi Devi.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Aug 21, 2007 at 12:20 PM

    Use FM NUMBER_GET_NEXT & check table NRIV,

    Use Get parameter Id, what kind of sales Organizations is used while creating & develop logic,

    Bye..........

    Add comment
    10|10000 characters needed characters exceeded