Skip to Content
avatar image
Former Member

Hi, Explain about Repair full request

Hi explain about repair full request and one more how many max no of partitions we will do

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Aug 21, 2007 at 10:04 AM

    Hi,

    have a look at the below thread..

    what-is-meant-by-full-repair-request

    you can also search forum , you will find a lot.

    Regards,

    Siva.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 21, 2007 at 12:55 PM

    Repair full request: If your data in data target does not load properly for a full update, you can use repair full request from infopackage scheduler. You can use if even after delta initialization and delta load.

    If it is E fact table paritions you are talking about then for 0Fiscper you can have max 18 (16 + 2)and for 0Calmoth you can have 14(12+2)

    Here 2 partitions for values that lie outside of the range.

    Assigns pts if helpful

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 21, 2007 at 08:22 PM

    If you flag a request as a repair request with full update as the update

    mode, it can be updated to all data targets, even if these already contain

    data from delta initialization runs for this DataSource/source system

    combination. This means that a repair request can be updated into all ODS

    objects at any time without a check being performed. The system supports

    loading by repair request into an ODS object without a check being

    performed for overlapping data or for the sequence of the requests. This

    action may therefore result in duplicate data and must thus be prepared

    very carefully.

    The repair request (of the "Full Upload" type) can be loaded into the same

    ODS object in which the 'normal' delta requests run. You will find this

    request under the "Repair Request" option in the InfoPackage (Maintenance)

    menu.

    SAP Note Number 739863 - Repairing data in BW

    REGARDING PARTITION

    IF BASED ON 0CALMONTH THAN 12+2

    IF BASED ON 0FISCPER3 THAN 122 OR 162 ( DEPEND ON VARIANT)

    Thanks

    Tripple k

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 22, 2007 at 05:17 AM

    Hi,

    First Full repair request will not affect the delta mechanism.

    With out affecting the delta, if you want correct some data, you can use this option.

    Normally, If we found some erronious data loaded, or some one deleted some records using selective deletion then we need to use this option otherwise no need to use this.

    Thanks

    Rajan

    Add comment
    10|10000 characters needed characters exceeded