Skip to Content
avatar image
Former Member

Short dumping while debugging externally

Hi everybody -

I am consistently getting a short dump while debugging externally through our portal, or straight through ITS. I am getting the same error message every time:

The ITS service "bbpsc04" had to be terminated because the Web AS has sent

the following error message:

Error message: " No additional external mode for new ABAP debugger available."

Message type: "E"

An error message had been received from the Web AS. No template was

found for the basic screen of the error message (program: "SAPMSSY3" screen

number: 131), and therefore the ITS service had to be terminated.

If you can, fix the cause of the error. Only then is the

error message no longer sent from the Web AS, and the ITS service can

then run again.

Does anybody know how to fix it so I am no longer getting this short dump?

Thanks very much - answers will be rewarded!

Abby

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Aug 21, 2007 at 07:14 AM

    Hi

    In the transaction, where are you putting break-point on a line, Before external debugging, logon via SAP GUI and go to say transaction SE38.

    On the Application toolbar, slect Utilities -> Settings

    Select ABAP Editor Tab, then , select Debugging tab there

    <u><b>Switch/Change the Radio button Debugger option

    from New Debugger to the Classic Debugger</b></u>

    The next time, you will start external debugging, the old classic debugger will be called and ther should be any errors..

    Do try this.. and let me know.

    Regards

    - Atul

    Hope this will help.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 22, 2007 at 12:49 PM

    Actually - we had exactly the opposite solution - the Classic debugger wouldn't work - but the new debugger would.

    Thanks!

    Add comment
    10|10000 characters needed characters exceeded