Skip to Content
avatar image
Former Member

DUMP Error

Hi Experts,

I am writing a report program using ALV.

I am using FM REUSE_ALV_FIELDCATALOG_MERGE.

when cursor comes to FM it goes to DUMP showing

Runtime Errors READ_REPORT_LINE_TOO_LONG

Except. CX_SY_READ_SRC_LINE_TOO_LONG

can anyone pls tell me why this error is coming.

the line where it is going to dump is inside the FM.

Regards,

Bindu.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    Aug 20, 2007 at 01:42 PM

    Yes, make sure that all of your source code lines are not greater than 72 characters across in the program which you are passing to the function module, this is a known issue when using this function module. Break the ones that are greater than 72 into two lines.

    REgards,

    Rich Heilman

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 20, 2007 at 01:42 PM

    hi

    just look into prgm if any of ur lines in the code exceed the length of the size of the report it shows like this...

    just chk out...

    for ex

    ur code line is 75 chacracter long

    but the page size could b only 72 chars..

    just write the stm in 2 lines....

    just chk ...hope it helps u

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 20, 2007 at 01:44 PM

    Hi,

    Try to use se38> utilities>setting -- editor--> downword compat line length 72

    then use pretty print option and activate the program

    aRs

    Add comment
    10|10000 characters needed characters exceeded