Unable to do action 'Complete Procedure'

[Former Member]

Hi,

I have done the correction in dev system and released the tasks. Next i released the TR from solman. Finally the TR was imported in quality system. After this when i try to complete the development using 'Complete Procedure' it issues following warnings and status remains 'In development':

1. Status was reset by system

2. Due to an exceptional situation, a condition was not met

3. Not all transport requests yet released

But when i go to task plan and again try to release transport requests it says 'there are no transport requests for import'.

As a result of this i am not able to proceed further. Plz help.

[Former Member]

Hi Kriti,

In think you are using Normal correction flow.

1.Have the transport request is moved to quality and found in quality system?

2.If the status is reset to indevelopment what happens when u try to complete procedure again?is it gives any error?

3.What is the Phase of the maintenance cycle when you do this?

Please give your inputs so that we can find the actual problem.

Thanks and regards,

Avinash.

[Former Member]

The problem was with the support pack. Higher support pack had to be applied.

[Former Member]

Hey Kriti Bhalla,

Did you import the TR into prod system,??

Try doing this,

i think you should use complete procedure after the import the TR into PROD.

Revert for any clarification.

Reward if my post was usefull.