Skip to Content
avatar image
Former Member

Upgrade of Devlopment box using CU&UC is done. How to verifiy?

Dear team,

We need your Advise at earliest possible as requested by our

Management.We have performed CUUC ( Combined Upgrade & Unicode

Conversion ) of our

Development System from 4.6C to ECC 6.0 on HP-UX 11i v3.

We are a bit concerned about the Unicode Conversion steps performed. Since we are not sure of the language assignments during upgrade if they were correct or not.

We opened a message with SAP and the reply was this is not a support issue but rather consulting.

How can we check/verify our system before proceeding to QA and production ?


Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    Aug 16, 2007 at 12:37 PM

    Which languages did you use productively before you migrated to Unicode and which languages do you have installed?



    Add comment
    10|10000 characters needed characters exceeded

    • So yes - then this error is expected.

      Someone entered that data apparently using an English login - and this is WRONG, one MUST NOT do that because the data is stored in the database with the logon language, thus the data is in ENGLISH ASCII characters.

      If you do the same thing again (logon in English and display), then it's correctly displayed.

      The Unicode conversion took the language key (which is is EN since the data was entered with an english logon) and converted it accordingly. Now it's corrupted due to this.

      There's nothing you can do but correct it manually because the user did the mistake of entering that data with the wrong logon language.