Skip to Content

The assessable value field is editable but not accepting values in MIRO

Dear team,

For import PO ( with IGST) with JCDB condition with IGST system is not allowing to accept values in Assessable value field.

We have applied notes

2475533

and the dependent notes. please note that field is not greyed out,rather system is not accepting values which we manually enters in this field.

This is experiencing after GST implementation

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Aug 15, 2017 at 02:16 PM

    Check the routine provided by SAP for import process. Be sure the routine has been maintained correctly for appropriate condition type. Be sure appropriate condition record is maintained in FV11.

    Also be sure you JCDB condition type is classified for MM pricing procedure.

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 15, 2017 at 05:00 PM

    Hello ,

    get this checked with ABAPer as the issue must be with the badi if it is not correctly implemented or notes are not in the sequence .

    also check note 2496604

    thanks

    kUnal

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 15, 2017 at 04:49 PM

    Hi,

    Thanks for the valuable feedback!. As per my preliminary check all the above are in tact.

    the customs invoice were able to raise with Assessable value (for tax base) earlier. But later after implementing the BADI

    the issue raised .

    Is the new BADI causing any issue ?

    Add comment
    10|10000 characters needed characters exceeded

    • Which BADI are you talking about ?

      To make the IGST calculation with regards to the assessable value, there is no BADI required. Just routine is required to place correct condition type. Can you please show us the screen shot of these below:

      Tax Pricing procedure with IGST condition type.

      Condition recoed for the IGST condition type.

      Coding of the Routine.

      Classify condition type.