Skip to Content
0

MIGO GR output in 2 different locations

Aug 15, 2017 at 12:44 PM

35

avatar image

hello all

after checking all the answers related to this issue, I could not find a suitable answer to my issue.

scenario is as follows:

we automatically print a GR slip using e new condition type we created (ZWE2).

all the proper settings in customizing are done, including print control and output determination/printer determination in Inventory management.

the printer is set for the plant/Sloc and also on user level.

But when I perform a GR, the spool shows 2 different spools and locations for printing this specific document!

Location A is wrong and location B is correct.

Location A, was already active even before we set up the actual correct location B to which the spool should print.

also MN21 is set up with the printer for location B

is there any other place in customizing that contains defaults for printers in MIGO?

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Best Answer
alisa majer Aug 15, 2017 at 01:10 PM
0

found the issue: another condition type with a higher more generic parameter was created with location A and so it included also my location and this second unrelated message was generated.

I added my plant to the secont message type and had it not printed.

I will close the thread

Share
10 |10000 characters needed characters left characters exceeded