cancel
Showing results for 
Search instead for 
Did you mean: 

2LIS_17_I3OPER datasource setup table load problem

former_member184594
Active Contributor
0 Kudos

Hello,

We are trying to extract data from 2LIS_17_I3OPER data source. However in RSA3, we see 0 records. We are trying to fill setup tables in OLIIBW tranaction however we are getting an error message below:

-------------------------------------

There is no extraction structure for event I3: Orders active

Message no. MCEX115

Diagnosis

You have called up the restructure for the extractor structures in

application '17' (maintenance). However, there is no extractor structure

active for event I3 (orders).

System Response

No dat from event I3 is copied to the BW interface.

Procedure

First activate the required extractor structures using the Customizing

Cockpit for Application '17' and start the restructure again.

--------------------------------------------

We have activated the datasource in RSA5 and in LBWE

Accepted Solutions (0)

Answers (5)

Answers (5)

former_member568104
Discoverer
0 Kudos

Hello Zahid,

i know the post is a bit older, but did you fine a solution?

I have the same problem

Thanks

Viktor

bhavinvyas
Active Contributor
0 Kudos

Hi Zahid,

If we consider all the points you taken care as suggested by the folks,

See OQN0 tcode in ECC,If user setup notification category for notification type = 03 (service notification). So, all records will be saved in 2LIS_18*.

Please refer this as well,

https://archive.sap.com/discussions/thread/3766486

Hope it helps!

Thanks,

Bhavin Vyas

former_member226999
Contributor
0 Kudos

Check the datasource in RSA2 to see all relevant structures are looking ok.

former_member184594
Active Contributor
0 Kudos

hi poojar,

we only have one client for dev and testing. we are able to extract other date sources. do you have another solution?

Thanks for your reply.

umashankar_poojar
Active Contributor
0 Kudos

Hi Zahid,

Is this on development box with two clients(one for dev and another for testing)? if yes, then copy the customized request to another client and test.

Thanks,

Umashankar