Skip to Content

Gather with Splitter and Join step in HCI

Hi - I am using Splitter, Multicast and gather in HCI iFlow.

gather step is not combining the data records as expected.

What I am doing here is using a splitter , multicasting the data to two branches where one branch contains actual data record and another branch I am performing some operations on the same data and trying to combine the both using join and gather..though I can see the data from both branches but gather steps not combining the data.

is it because of splitter sending two records and gather also expects two records only, here as per my iflow there will be four messages sent to gather? Has any one encountered this issue?

Regards

Rajesh

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Feb 21 at 02:45 PM

    Hi Rajesh ,

    For the above scenario try adding a gather in both the branch of the multicast before using join and then join both the messages.

    Many Thanks ,

    RuchitaV

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Sep 16, 2017 at 11:10 AM
    -1

    Before the gather, you need to use Join.

    Add comment
    10|10000 characters needed characters exceeded