Skip to Content
avatar image
Former Member

How to create scenario if both Message structures are same.

Hi All,

In my scenario the sender and receiver system message structure is same.

Is Message mapping is resuired....? if not please give me some inputs on how the data will be transfered ?

is their any difference from the typical configuration ?

How to design and configure the scenario.

Thanks,

Aravind.Pujari

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Best Answer
    avatar image
    Former Member
    Aug 08, 2007 at 11:37 AM

    Hi Arvind,

    if sender and receiver message structures are same, then one datatype, messagetype would be enough.

    in message mapping, select same message type both in source and target and do one to one mapping.

    Alternatively, if it is file dumping, directly u can configure communicationchannels sender and receiver.....by the path u mention in CC file will be transferred.

    Regards,

    Ravi.

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 08, 2007 at 12:11 PM

    If u just want to pass the data as it is, then mapping is not required.

    And if u dont want any mapping, then u can avoid whole Integration repository step.

    Have a look here

    /people/william.li/blog/2006/09/08/how-to-send-any-data-even-binary-through-xi-without-using-the-integration-repository

    Regards,

    Prateek

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 08, 2007 at 11:36 AM

    Hi,

    There is no need of message mapping if both the message types are same..

    In the configuration u need to have only one Interrface determination and receiver determination.

    Regards

    Santhosh

    Message was edited by:

    Santhosh Kumar V

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 08, 2007 at 11:45 AM

    Message Mapping and Interface Mapping are not required in your case....though separate interfaces will be there in IR

    In ID will proceed with the same way as u normally do

    Add comment
    10|10000 characters needed characters exceeded