Skip to Content
avatar image
Former Member

No message processing until now

Hi All,

I am working on a file to file scenario. The XI engine is able to pick up the file. But I am unable to see the output. I am unable to see it in MONI also. Also in the adapter monitoring, both the sender adapter and receiver adapter are green.

<b>The sender adapter monitoring shows this: </b>

Sender Adapter v2723 for Party '', Service 'bs_1748':

Configured at 2007-08-08 06:43:47 UTC

History:

- 2007-08-08 09:13:18 UTC: Polling interval started. Length: 10.000 s

- 2007-08-08 09:13:18 UTC: Processing finished successfully

- 2007-08-08 09:13:18 UTC: Processing started

- 2007-08-08 09:12:50 UTC: Polling interval started. Length: 10.000 s

- 2007-08-08 09:12:50 UTC: Processing finished successfully

<b>The receiver adapter monitoring shows this:</b>

Receiver Adapter v2405 for Party '', Service 'bs_1748':

Configured at 2007-08-08 07:07:08 UTC

No message processing until now

Can some one tell me why i am getting this error .

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    Aug 08, 2007 at 09:26 AM

    Hi,

    Please try to find your message in the MDT. Here are steps to get there:

    -> Goto the url http://<xiservername>:<xiport>/mdt

    -> Enter the details of your sender

    -> Click start button

    This should give you more information

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 08, 2007 at 09:25 AM

    what is the processing mode for ur file sender.

    I dont think ur file is picked up by XI properly

    Regards,

    Prateek

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Aug 08, 2007 at 09:30 AM

    Hi,

    Check the mapping , parameters of sender and receiver adapters.

    Regards,

    S.RamNarender

    Add comment
    10|10000 characters needed characters exceeded

  • Aug 08, 2007 at 09:45 AM

    Hi Kathik,

    You test your configuration in ID..

    goto -


    > tools-----> testconfiguration

    here enter all the parameters for sender/receiver ...put your actual payload data and test ..

    I hope this might help you..

    vasanth.

    Add comment
    10|10000 characters needed characters exceeded