Skip to Content
0

Bom Usage 6 in Costing 1 View

Aug 07, 2017 at 03:40 PM

94

avatar image
Former Member

Hi Friends,

Please check the below. My selection ID in costing variant has priority for BOM Usage 6 and then 1 in sequence. Production team maintained BOM's for both production and Costing ( Usage 1 and 6). When I do a cost roll up I was expecting system to pick costing bom first but it is looking for production BOM. If I maintain Bom usage 6 in Costing view 1 - Qty structure data system is picking Costing BoM but if I leave it blank it is going for Production bom. I thought selection ID will help system go for costing bom without maintaining usage 6 in costing 1 view. In MRP4 Selection method is 2 and a production version is maintained but my understanding is it is purely for production but not used during cost roll up.

Please help!!

bom.jpg (73.5 kB)
10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

2 Answers

avatar image
Former Member Aug 15, 2017 at 06:10 PM
0

Gurus, Any thoughts?

Share
10 |10000 characters needed characters left characters exceeded
Jerson Medina Salmeron Aug 24, 2017 at 02:18 PM
0

Surya,

For Product Costing processes, the data between PP and CO-PC must be the same, you must check that the manufacturing version is the same and that it is derived in CO-PC, you must do the same with the Bom and Routing Data views within CK11N (QTY STRUCT View.) Go to check BOM in tcode CS03, Routing in tcode CA03 maybe this help. Regards

Share
10 |10000 characters needed characters left characters exceeded