ECC 5.0 Two Errors .....

[Former Member]

Hi,

I have installed system ECC 5.0 as sandbox.

With Win 2003 Oracle 9.2.0.6 with 2 GB RAM. HDD 320GB 160+160 Two HDD's (one partiion on each HDD of 160GB)

First Question :

When i am trying to execute DB02 its giving me a pop up called "will take some time to collect from db monitors " when i said yes.

The process is ending with TIME_OUT Error ? How to overcome this.

I suppose 600sec is not enough for collecting stats.

I tried to increase max runtime for dia process to 1000 but after restarting msg sever is not starting...

Question Two :

When i am tring to change any parameter in rz10. like changing no of wp, changing size of PHY_MEM etc.

After restarting the server for changes to apply i am not getting any instance in MMC console. so that i can't start my sap.

After i overwrite profiles from backup. then its working fine?

What may be the cause ?

Thanks in Advance.

[Former Member · Accepted solution]

Hi,

1. Change parameter through RZ10

rdisp/max_wprun_time = 1200

or add above line in Instance profile from OS Level (Not preffered)

2. Check for profile consistency. Due inconsistency in profile parameters you will facing the problem. When change profile and save it all the parameters will be commented. So, system can't read parameter.

Caution: Take backup of all profile and perform the job.

Regards,

Ganesh

****Reward points if Helpful*****

[Former Member · Accepted solution]

Thank for your quick replies .

I have already imported the active servers profiles. and tried to change the parameters.

And checked consistency of profiles before restarting the server.

And the solution about editing it at OS level is not much feasible.

And what about my first question?

DB02 ?

Plz Help.....

[Former Member]

Hello !!!!!!!!

My problems still not solved. someone give it a try..

Thanks in Advance

[Former Member]

I did not remember the exact Oracle Versions, but there are some out which have a bug in calculating the freespace in the database (extreme long runtimes of special sql-statements)

set parameter

rdisp/max_wprun_time = 0

in the instance profile.

restart the instance and run it again with patience.

Peter

[Former Member]

Thanks for reply,

But i found your reply some what strange.

What is the use of setting that parameter to 0 . then dialog process will not run more than 0 sec.

Or there is any other logic behind that?

Thanks in Advance

[Former Member]

Hi

Dialog workprocess wont timeout if the value is set to 0

Thanks

Prince Jose

[Former Member]

Thank you for your quick reply..

I think this problem is going to solved with this effort.

And i would like to have answer to my first question. So can you plz look into it ...

And where can i get a good post installation steps for ECC 5.0.

Like setting parameters,buffer tunning etc

Plz help me with that.

Thanks in Advance....

[Former Member]

I don't like this RZ10 to maintain profile parameters.

you can do a lot of finger trouble which will result in non startable systems.

first you have to import the profiles of the active servers.

after that you can try to add/change profile parameters and activate them.

peter