How to create Rounding Profile which gives value upto 3 decimal places without rounding up/down

[former_member480322]

Dear Experts,

I'm facing this issue in SAP TM where I have to create a Rounding Profile with no rounding up/down. It should be just rounding for 3 decimal places. e.g.

The Chargeable weight is 0.257333 KG so using Rounding Profile, it should be 0.257KG.

I saw options in SPRO and found 4 options of Rounding Type:

1. Rounding UP

2. Rounding DOWN

3. Rounding to Next Figure

4. A hyphen (-)

When I'm selecting a hyphen, it's not allowing me to save Rounding Rule under Rounding Profile.

-Arpit

[NiteshSaluja1]

Hi,

If i understand correctly, do you mean limiting the number of decimals?

BR//

Nitesh

[former_member480322]

Hi Nitesh,

Yes and it should not be rounding up or down.

Arpit

[NiteshSaluja1]

Dear Arpit,

Check the setting on the UOM level, field Decimal places and decimal places rounding.

This can be found under SPRO -> SAP NetWeaver->General settings ->Check Units of Measurement.

Hope it helps.

BR//

Nitesh

[former_member480322]

Dear Nitesh,

Thanks for your reply. I checked UOM level and Decimal pl. rounding is 3 only. The Challenge is here using Rounding Profile in Chargeable Wt. as Scale in a Rate Table. I have no Rounding Profile which can limit the number of decimal to 3. Even if I don't use Rounding Profile for Scale- Chargeable Wt, it's not limiting the number of decimals to 3.

So in this case I think I need to have 3 decimal places rounding profile. Appreciate your help!

-Arpit

[former_member480322]

Dear Nitesh,

Could you please update? Thanks in advance.

-Arpit