Skip to Content

Change the cProject ID with PS


We have implemented, cProject integration to PS and it works fine..!! Since we are already using PS ( and have a number range for Projec & WBS), we would like to use the same number for cProject as PS.. For E.g., cProject creates a project with 14XXX and PS creates ZZ-101010, at the end of save of cProject, we would like to overwrite 14xx with ZZ-XXX.

For this, we tried to modality the entry in table DPR_project-PROJECT_ID. This field store the value 14XX values and Primary key is stored in GUID. This was done on BADI for PS Save.

However, after changing the value in BADI , when control goes back to PPM ( from PS), the values are again reset to 14XX and there is no change in Project_ID.

Please advice,the best approach to change the ID in PPM ( Any PPM BADI) etc..

I have already looked at DPR_ATTRIBUTES & DPR_DEMO_SUBSYSTEM and it did not help.


Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

0 Answers