Skip to Content
0

The system does not automatically set the storage lock

Aug 01, 2017 at 12:10 PM

60

avatar image

When i am removing the entire stock from My bulk storage type it should automatically remove the storage lock , this functionality was working fine before system upgrade to EHP4, but after upgrade this is not happening.

Can i known what might be the reason though the settings remain same even after upgrade..

10 |10000 characters needed characters left characters exceeded

it should automatically remove the storage lock- Where do you see this lock, can you please share the screenshot

0
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Best Answer
Neil Murphy
Aug 02, 2017 at 08:53 AM
1

You could run report RLTLQUAB to check for inconsistency in the bulk storage type (inconsistency between LQUAB and LQUA the quants table). There could be an inconsistency in the quantities. If a result is found in RLTLQUAB, open a SAP Support incident for further analysis.

Share
10 |10000 characters needed characters left characters exceeded