Skip to Content
0

Manuall Entry of the Sample size in the Inspection lot creation

Aug 01, 2017 at 11:02 AM

51

avatar image
Former Member

Hi Gurus,

How to make the manual entries of the sample size in the inspection lot creation/change.

Inspection plan is created for the material . During the GR of the purchase order the sample size is created automatically .But the requirement is to have manual entry of the sample size.

After the inspection lot is created the sample size field is only in Display mode it should allow changes to the field .

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

RAJA SEKHARA REDDY BANNURU Aug 02, 2017 at 05:12 AM
0

Hi Goutham,


By setting up the Master data, as shown below, you may get the option, for the Manual entry of the Sample Size
But, with this set up, you will not be able to get connected with the Inspection Plan/Characteristics.. etc , in the Inspection Lot. .
So, Not Advised to go/proceed with this

Thanks & Regards : Raja Sekhara Reddy B


gffv2.png (278.3 kB)
Show 2 Share
10 |10000 characters needed characters left characters exceeded
Former Member

Hi Raja Sekhara Reddy ,

Thank you for the prompt reply .

But if the manual sample entry is selected then the inspection plan for the material is not triggered and results recording for the inspection lot is not possible.

Regards,

Goutham

0

Hi Goutham

Yes, you are Correct.
Because of this only, I mentioned as Not Advised to go/proceed
May be, there is any other way, need to get other Experts Comments/Inputs/Solutions..


Thanks & Regards : Raja Sekhara Reddy

0