Skip to Content

QA08 ( The button "Class Selection")

Aug 01, 2017 at 07:14 AM


avatar image
Former Member

Hello everyone!

Could anybody tell, how to work this button?
The sequence of my actions is following (see the image).
The question:
We have 3 materials in the class (as we see on the picture 3), but at the last picture we have only 1 material, which at the list of materials in the particular class is the last.
I supposed, that all materials from this class must be in the list for mass change of QM inspection setup. How works this button in practice?

Thank you.

123123.png (209.4 kB)
10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Craig S
Aug 02, 2017 at 08:27 PM

You are running QA08 in change mode.

When you search by class it is only finding one material that actually has an existing inspection setup to change.

My guess is that if you go into the other two materials, you'll either find no QM view created, or no valid inspection type setup for the inspection type you are changing. Therefore only one material is presented.

10 |10000 characters needed characters left characters exceeded