on 07-28-2017 9:29 PM
Hi,
I have a report with 3 tabs and 3 tables on each tab. I want to place a "input Control" where it will show me a specific tab and table on my report. So I will put 1 parameter eg. I want tab 1 to show only 1 table, not all 3, is this impossible?
Hi Dimitrios,
Currently, you can't switch tabs using input controls, but, you can hide/show tables. So, my suggestion is to have all the 9 tables in one tab and show/hide depending on selection in Input Controls (with custom LOVs). Tr using the logic from the below blog, having LOVs as Tab 1 Table 1, Tab 1 Table 2, Tab 1 Table 3,... and so on to ... Tab 3 Table 3, and use the selection from the input control to show/hide blocks.
https://blogs.sap.com/2015/12/03/dimensions-as-input-control-dynamic-control/
Thanks,
Mahboob Mohammed
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Dimitrios,
You could create a document link and select a different 'tab' of the report as the target area to allow the user to jump to it rather than clicking on the tab. Performance may be an issue versus the manual step.
Regards,
Andrew
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.