Skip to Content
avatar image
Former Member

Issue with variable selection

Hello friends

I have created a sample iView which has a BW query. I have attached a variable form to the input of the Query and a table view to its output. However when I am deploying the iView, I cannot see a selection list for the variable and neither any data in the table

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Best Answer
    avatar image
    Former Member
    Jul 19, 2007 at 06:20 PM

    hi Rishi

    Please elaborate your exact requirements.

    Regards

    Navneet

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      So you have a form in which the user selects value from a drop-down list and once user submits the table should be populated with appropriate data.

      Steps:

      Start--


      Form
      DataService

      Table
      --


      End

      1.Place a form , next a Data Service and a Table which pulls data from this data service.

      2.Add a Dop-Down control to the form and configure if its a Static or Dynamic as needed

      3. Connect the Form OUT port to DataService IN port(drag and drop) , select the connector/line which was created and click configure.

      4. Map the Drop-Down control to appropriate column (This is available in bottom right of the screen)

      5.Click on the table and select the columns which you would like the Table to have.

      6.Save and Run.

      This should run as desired