07-19-2007 12:45 PM
Hi All,
Requirement is to send an idoc to XI only if it satisfies the filter condition. Currently, the idoc is getting triggered even if the filter conditions are not satisfied. However the segment with the relevant filter fields does not appear in the idoc.
The config is complete in BD59, BD64, BD52 (for change pointers).
Does the filter in BD64 work at the idoc level or segment level? If at segment level, then what is the way to stop the idoc from getting triggered if it does not satisfy the filter conditions?
Thanks,
Shivali
07-19-2007 12:51 PM
hi
just refer to the link below
http://www.sapmaterial.com/?gclid=CN322K28t4sCFQ-WbgodSGbK2g
regards
ravish
<b>plz dont forget to reward points if helpful</b>