SMD and Self diagnosis not working

[Former Member]

Hi Solman's,

I put my system to Stack 12. After that, SMD and Self Diagnosis not working any more. Here the message:

URL http://sv030488.myco-group.com:8001/sap/bc/webdynpro/sap/dswp_sd_self_diagnosis call was terminated because the corresponding service is not available.

Note

The termination occurred in system MMS with error code 403 and for the reason Forbidden.

SM59 connection test shows:

ERROR: program WEBADMIN not registered

how to register ??

Best regards

Wolfgang

[former_member125914 · Accepted solution]

Hello Wolfgang,

You have to activate the service dswp_sd_self_diagnosis.

Run transaction SICF, on Service Name, enter dswp_sd_self_diagnosis.

Right-click on the service and select "Activate Service".

Run the Setup Wizard of Diagnostics System on SMD to register the program WEBADMIN.

Best regards,

Paula

[Former Member]

Hello Paula,

you are great.Now it's working fine again. But I am a little bit confused, becaus the problem not exsists with stack 11.However, I give you 100 points.

Best regards

Wolfgang

[mathias_dieckhoff]

Hi Wolfgang,

after updating to Stack12 please check also the part http-services in the implemention guide.

I had to activate 3 more services after upgrading to stack 12.

regards,

Mathias