Error while specifying condition in Interface Determination

[Former Member]

Hi all,

I am facing a typical problem

It's a proxy to file scenario with mutiple receivers.

In the interface determination when we are trying to specify the condition, it gives the following error.

"Message interface does not exist in any software components installed on this business system".

Detailed solution would be highy helpful.

regards.

younus

[Former Member · Accepted solution]

Hi;

If you are using a business service then you will have to specify the interface in it .

Mudit

[Former Member]

Hi All, Thanks for the help,

I have a new error,

Its a proxy to file scenario, using FCC.

In the receiver communication channel i have specified the fixedFieldLengths

and fieldNames.

In Channel monitoring its gives the error as "Channel has not been correctly initialized and cannot process messages"

But when i stop and start the specific channel the error displayed is"Conversion initialization failed: java.lang.Exception: java.lang.Exception: Error(s) in XML conversion parameters found: Parameter '.fieldFixedLengths' or '.fieldSeparator' is missing "

Need your help to solve the problem.

Thanks in Advance,

younus

[bhavesh_kantilal]

Make sure that the Business System is asscoaited with the corresponding SWCV at the SLD . If yes, then refrsh SLD cache.

if no, go to the SLD add the SWCV to the Business System, refresh Cache in the ID and then give it a shot.

Regards

Bhavesh

[Former Member]

Hi

In this case it seems that the Message interface is not created which has to be used in the scenario. For the business system used u need to create a interface so that it can be used in the interface determination step. Once that is done you can specify the condition in interface determination.

Regards

Sumit

[Former Member]

Hi,

I am using a Business System at the source side and Business Service at the target.

What could be the problem.

thanks in advace,

younus

[former_member184619]

Hi Yonus,

It seems that u have made changes in SWCV after doing the configuration.

Try out thess:

STEP1->In ID

Go to menu :--> Enviorment->clear SLD cache

Step2->In IR

Go to menu :-->Tools->Transfer from SLD->Update application component and then step 1

Step3->IN SLD

Check the the SWCV u r using is associated with the Business system u are using. Check for the checkbox for SWCV in Business System.

Sachin

Message was edited by:

Sachin Dhingra