Search help is not showing list of objects available in ID

[Former Member]

Hi Everybody,

I developed some business objects( Message Interfaces ) in Integration Repository and transported these objects from developement system to Quality system. After successful transportation i am able to see these objects in IR

(Quality system) also. While doing configuration in Integration Directory of Quality System, i need to assign this Messge Interface to one of Business service. We all know that we will assign this Message Interface by using search help at Receiver/Sender level in Business service. But here in the search help i am not able to see my Message interface which actually exists in Integration Repository.

I have tried out by clearing cache and make sure that the object is active, even then also i am not able see my message interface in search help.

So, please help me if any one gets this situation earlier and how to resolve this?

[Former Member]

Hi Vijay,

Could be a Cache Issue. CHeck out the cache notifications in QA IR. Do you see a success there ? If not refresh the cache manually.

Regards,

Sumit

[Former Member]

Hi Sumit,

I have cleared cache using SXI_CACHE, even then also i am not able to see the interfaces.

Thanks,

Vijay Kumar T.

[Former Member]

Hi Vijay,

Did you check the cache notifications in IR?

Refresh Cache using browser..

http://<xiserver>:j2eeport/CPACache/refresh?mode=full

When you go to SXI_CACHE in QA server . Click on Mappings on the left hand side and see if the mappings are available in cache.

Regards,

Sumit

[Former Member]

vijay

just a quick thought.

Did you enable the "all systems" radio button and check if your interface comes up?

regards

krishna

[Former Member]

Hi Krishna,

Thanks for quick reply. 'All systems' radio button will be shown for the Business Systems but not for Business Services. Here my problem is, i am not able to assing any interfaces( Outbound/Inbound ) for my business service, which are available in IR.

Thanks,

Vijay Kumar T.

[Former Member]

Got you

Going through the following thread should fix your problem (same issue)

Good luck

regards

krishna

[Shabarish_Nair]

Try;

1. Verify if the cache is refreshed. Else refresh the cache, SXI_CACHE -> complete cache refresh

2. Verify is you are looking into the correct message interface. As inbound interfaces will not appear where the outbound should be, or the vice versa.

[Former Member]

Hi Krishna,

I am searching for right interface only. Here i am searching for outbound interface only but not able to find.

Thanks,

Vijay Kumar T.

[Former Member]

Hi Vijay,

Is the problem related to a single interface? or you can not see any interface.

Regards,

Sumit

[Shabarish_Nair]

<i>I am searching for right interface only. Here i am searching for outbound interface only but not able to find.</i>

>>>

can you do a check in IR. Verify if you have created the interface as an <b>outbound</b> one in <b>IR</b>.

[Former Member]

Hi Sumit,

I am able to see some interfaces but not the one which is i am expecting.

Thanks,

Vijay Kumar T.