Hi,
We have a Discovery system with WAS and SQL2005 sitting on the same system. We're trying to move the DB to a new System.
We have been able to connect to our New SQL2005 host and our ABAP interface is working fine, even the portal is working fine. However when we try to test our TMS using the new DB server it gives an error, some notes suggested that we run R3Trans d first and this is the error message that we get.
2EETW169 no connect possible: "DBMS = MSSQL --- SERVER = 'IWDFVM2160' DBNAME = 'ERP'"
The new DB server is SAPSQL2005, IWDFVM2160 is the OLD DB server, IWDFVM2160 also happens to be the server where WAS is running.
Is there some configuration that needs to be changed? Any advice on how to get the TMS working will be appriciated.
Thanks and Regards,
Aniruddha
2 Answers
-
Best Answer
Former MemberPosted on Jun 25, 2007 at 03:07 PMHi
You must be getting error while importing the request into the system also like "Connetion Failed" and also when u perform tests for tool in STMS.
The problem lies with the environment variables for all the user like administrator, sapservice<sid>, <sid>adm!
Check that all required parameters set in the old system exists for the users in the new system.
Probably the error is because of this environment variables for the above users.
It should solve your problem.
Regards
Sumit
[reward with points if useful]
Add comment
-
Former MemberPosted on Jun 20, 2007 at 01:25 PM
Discovery system is meant as a learning system. you are not supposed to change or move componets around.
1.) Hostname must be iwdfvm2160
The hostname might have been changed during the cloning to something similar like PREREFFE-xxx .
2.) Domain name must be wdf.sap.corp
3.) Do not change password for user Administrator to other than sap123
Start of Integration Builder might no longer be working resulting in 500 Internal Server Error
4.) Drive letters
Data drive must be D:
DVD drive must be E:
Drive letters might have been changed during the cloning process. Check after boot up that this is correct.
5.) If no network connection is established, NS lookback adapter needs to be installed.
If no network connection is available the discovery server is running stand-alone and isolated.
6.) Swap area should be 6.651 GB distributed over drive C: and D: with system managed size
Smaller Swap area might lead to start-up errors in the J2EE-instance IWDFM2160 10 staying in yellow in SAP-MMC
7.) Make error entries in event viewer readable
Registry modifications might be necessary to synchronise registry with environment variables for ERP and make error messages readable from cryptic before.
8.) MS SQL Server Evaluation version (180 days) might need to be replaced by the corporate version with a permanent license.
9.) Boot.ini
Boot.ini should look like this:
[boot loader]
timeout=30
default=multi(0)disk(0)rdisk(0)partition(1)\WINDOWS
[operating systems]
multi(0)disk(0)rdisk(0)partition(1)\WINDOWS="Windows Server 2003, Standard" /noexecute=optout /fastdetect /PAE /3GB
Add comment
Add comment