file to file scenario

[Former Member]

Hi experts,

I am new to the sap xi while practising the file to file scenario I completed all the

steps , from sender point of view I kept the mode as delete and in the receiver side

I kept mode 'add time stamp' and also i checked it 'create' also proble It is deleting the file from the source directory but it is not able to create again with some other name in other directory.

Advance thanks,

Srinivas.D

[prateek · Accepted solution]

Check the following

1. Receiver filename and location r provided properly.

2. File Server has proper authorization to create the file

3. Status of ur msg in sxmb_moni

4. Status of file adapter in RWB.

5. Receiver Communication channel is activated

Regards,

Prateek

[Former Member]

thanks

[Former Member]

hi raj

when i cliked on adapter engine it showing the messages 2 for sender and 2 for receiver and the status is also in green and that i observed that integration server

is in red color is there any problem with this.

Thanks & Regards,

Srinivas.

[Former Member]

Srinivas,

Please check your sender communication channel in adapter monitoring. If it is green then see sxmb_moni for your message. If it is chequred flag then check receiver communication channel. You should find an error in any of these. Please post the error back so that somebody can help you out.

---Satish

[Former Member]

Hi raj

Thank for u quick response but in all ways but i did'nt get it and one more thing

when i go the transaction sxi_cache it not displying anything even in sxmb_moni

no messages are displaying.

Regades,

Srinivas.

[Former Member]

Hi,

Is it a newly installed system! I doubt, whether you are done with all post installation steps.. plz chk.

regards

[Former Member]

hi raj,

I checked with component monitoring in which I gone for adapter moning there file adapter status is in green and it displaying that there no exitsing in sender side or

Receiver side .

Thanks

Srinivas.

[justin_santhanam]

Srinivas,

<i>it displaying that there no exitsing in sender side or Receiver side .</i>

Where u got the above message, can u please clarify it.

Like above frnd's suggested whether ur interface is success ? Check in sxmb_moni ?

Best regards,

raj.

[Former Member]

Hey

did you check sxmb_moni,for any mapping error,also copy the payload from sxmb_moni and test ur mapping,check the receiver file adapter in RWB .

thanx

ahmad

[justin_santhanam]

Srinivas,

The receiver file is not creating in the target directory , am I right? Go to RWB, choose component monitoring, click Adapter engine node , in the bottom choose adapter monitoring or Component monitoring(based on ur SP). Then choose the receiver comm channel and check the status of it.

Reply back!!!

Best regards,

raj.