on 06-13-2007 9:18 PM
Hi Folks,
The following settings have been made
NUMRG COMP is set to X
Number Ranges-
$$S has two number range intervals-10000000-19999999 is External and 20000000- 29999999 is internal.
Tested in Dev and works fine.Transported the same
In Q one of the clients works well but in the other client for external the following message appears-The number range is not in any valid external interval"
What could be the issue?
Hi,
Check the Same settings in the Quality Server too. Then look for the authorization in the server.
Good Luck
Om
Reward it if helpful
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Did you solve your problem yet?
we had subgroup $$$$ in our golden client, it works there, but it doesn't work in other clients after we SCC1 transport over.
We checked it transported successfully in other clients, compared 2 clients, the configuration are the same in oonr transaction.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Check number ranges in other quality client
check that it trans port properly or not.
if not then create number ramges there.
Vicky
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi
Switches may be problem.
Check it again.
Manoj Shakya
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
hi smrithi
Please check once the switches is activated in the quality just check the number ranges and features relating to that.Just check if the transportaiton is done properly or not
ok
bye
Naveen
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
108 | |
12 | |
11 | |
6 | |
5 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.