06-12-2007 6:57 PM
Hello all,
I have an issue with the table lines being split between pages. I need the line to be, in its entirety, on one page. Right now it is splitting up the line on two lines if it is at the bottom of the page. How can I protect a line to stay on a single page?
Regards,
Davis
06-12-2007 7:15 PM
In the Table Node, under the Table Tab, in the Line Type definition there is a checkbox for 'No Page Break'.
You can also use Page Protection in the definition of your Paragraph Format in your SmartStyle.
Message was edited by:
Matt Nagel
06-12-2007 7:15 PM
In the Table Node, under the Table Tab, in the Line Type definition there is a checkbox for 'No Page Break'.
You can also use Page Protection in the definition of your Paragraph Format in your SmartStyle.
Message was edited by:
Matt Nagel
06-12-2007 7:17 PM
Matt, thanks. I did not see it there; I was looking at the individual lines and not the line types.
Thanks a lot!
Davis
06-12-2007 7:20 PM
Davis,
Check the 'No Page Break' checkbox under table node -> line type attributes.
Page protection attribute
Switch for page protection.
Use
Page protection switch.
In some cases you may want to avoid that text is divided by a page break. Therefore, you can protect text sections with a page protection.
Page protection can extend to
a paragraph
a text node
all output within a folder, for example, several text nodes combined in this folder.
a line type (table node)
If on the current page there is not enough space left for the protected text, it is displayed entirely on the next page.
Rgds,
Naren
06-12-2007 7:23 PM
Somen, I was going to use the Page Protection switch but that is grayed out in every node. Why would it be grayed out (unavailable)?
Regards,
Davis
06-12-2007 7:29 PM
I know its greyed out in my version (4.6C). I think it may be available in higher versions.
06-12-2007 7:47 PM