on 06-11-2007 2:52 PM
Hi all,
I have created the file to jdbc scenario where i am done with the design part.
i have created the communication channel in which the sender communication channel is a business service and the receiver communication channel is created in the business system.
When i create the interface determination my inbound interface is not listed in the list of inbound interfaces..
wat could be the problem?
Regards
Arun
When you get the window to select your inbound interface, by default the radio button From Business system <Receiver business system> will be selected. Just change the selection to All.
Regards,
Jai Shankar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Arun,
Double click on the Business Service and the right hand window , check whether the sender/receiver interfaces are added over there.
Best regards,
raj.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Arun,
I think you have to add the software component(s) holding your Message Interfaces to the Business System in the SLD. Only interfaces in SWCVs that you defined for your business systemshow up in the pick-list.
After you made this change in the SLD, make sure to clear the SLD data cache and refresh the interfaces on the Business System in the Integration Directory.
Kind regards,
Koen
<i>When i create the interface determination my inbound interface is not listed in the list of inbound interfaces..
</i>
1. Double click ur Business service/system. There under the outbound/inbound interfaces, specify ur corresponding interfaces
2. Make sure that ur interfaces r activated
3. Recheck whether u have created the Message Interface as "Inbound" and not "Outbound" by mistake
Regards,
Prateek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
101 | |
13 | |
13 | |
11 | |
11 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.