on 06-06-2007 2:23 PM
Dear all,
does anybody know if it's possible to cancel a dunning run after the notices have been printed (except manually by changing all documents and all master data)
WITH ADVANCE THANKS
KRISHNA KUMAR
Hi everybody,
I found the report RFCORR14 which allows this action. There is also the OSS note 6591 for additionnal informations.
Regards,
Didier
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI,
I had this issue where there was a problem with the dunning run and I could not re-dunn.
One of our ABAPers wrote a program based on SAP note 186095. This released the entries from the MAHNS table.
Hope this helps
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
I had this issue previously and had one of our ABAPers write a program based on sap note 186095.
This deleted the entries from table MAHNS and allowed me to re-dunn.
Hope this helps.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Krishna,
Why do you want to re-run the Dunning run after printing them out?
Anyway there is a program SAPF150D2 that enables you to re-edit the Dunning run. However whilst a Dunning letter is not a legal letter it is binding and so to add some control to SAP I am sure there is not a way where you can cancel the run and start again. What is to say that you send the wrong letters out.
You can create a simple program to go to FB09 to delete the Dunning level and the date of the last Dunning run.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Krishna,
I have the same problem. Did you find a solution ? That interests me.
Thanks in advance,
Didier
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Once dunning notices are printed, I don't think it is possible to reset it. May be you can check in the following path of the Dunning run in Transaction code F150.
Menu > Environment > Reorganization.
Thanks
Murali.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
98 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.