on 06-05-2007 10:00 PM
Hi,
When I tried to run the debug program RSPLS_PLSEQ_EXECUTE, after I choose the planning sequence, I can not find the the variant which I created for the planning sequence under data modeler. when I tried to run the PS without the variant, I get the error message. anybody know how to fix it.
Thanks in advance.
Hi JW,
when you enter your planning sequence, push ENTER. Then you will notice your selection variant will appear
regards
D
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
That's right,
we are working on SP12 ... and there we don't experience these problems
regards
D
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
We are having the same problem where we don't see the available variants after pushing enter in RSPLS_PLSEQ_EXECUTE. I suspect that we need to flag the variant as "Cross-User Variant" when we create it but when we do that, we get a program error and we cannot save it. Has anyone else seen this or know how to correct it?
Thanks, Todd
I did that, but it still not vairant display, I found a OSS notes. looks like we need to implement SP12.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
23 | |
11 | |
9 | |
8 | |
5 | |
5 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.