IDoc - XI - Web Service configuration

[Former Member]

Hallo

This is the problem we are facing :

We get an IDoc as Inbound, do some mapping and then send it to a WebService. The problem is that when we do so, we get a series of errors. Apparently the problem is that when the web service receives our messages it replies with a (simple) message as well. The point is that as far as I know IDocs cannot be configured for synchronous mode, (and when we tried it we failed) so we have nothing to do with the incoming message.

these are the messages from the Integration Monitoring/Message Monitoring

Error Category OUTBINDING

Error Code CO_TXT_ROUTING_BACK_ERROR

We don't have access to the Receiver System and the WSDL file is sent by them

[Former Member]

Actually there were plenty of problems, but using xml-spy was pretty helpfull.

[Former Member]

Thanks, I would like to ignore the response but if they send it anyway (as it seems to be the case) what should I do? I tried ignoring it and I got the message above.

[bhavesh_kantilal]

Was it an Asynch call to the webservice? If yes, then I dont think this should be an issue.

But aint sure coz have not given this a shot.

Regards

Bhavesh

[Former Member]

Actually, I don't know. I will look arround it and try your previous suggestions too.

Just a not-so-XI question.

I tried to test the Web-Service using XML-SPY and the WSDL that they have provided for us. When I do so, i get an error 504, "HTTP error:could not POST file 'soap/CreateOrder' on server 'xx.xx.xx.xx' , where http://xx.xx.xx.xx:80/soap/CreateOrder is the URL that we are using during the configuration of XI. Would this imply that the error is that we just have wrong URL (but how since it is retrieve from the WSDL itself?).

[bhavesh_kantilal]

Markos,

Looks like a URL issue to me.

1. Copy this url and try to open this in a Browser Like IE and see if it gets loaded.

2. Make sure that the proxy server etc are valid.

3. Try using a tool other than XML Spy.

Regards

Bhavesh

[bhavesh_kantilal]

Markos,

2 options,

1. Do you want to do something with the Webservice response?

If no, then use a Asynchronous Inbound Interface for the Webservice.

2. If you want to deal with the webservice response, then either use a BPM or change the source from Idoc to proxies.

Regards

Bhavesh