Receiver Determination, Configure Receivers, Condition configuration alert

[Former Member]

Hello Colleagues,

when i try to configure condition area under Configured Receivers at Receiver Determination i get following notification:

Message Interface does not exist in any software components installed on this business system.

Could tell me someone where is the problem?

Many thanks in advanced!

Regards,

Jochen

[Former Member]

closed

[bhavesh_kantilal]

If you do not want to get this warning, go to the SLD, go to the technical system under which the Business System is created and add the SWCV to the technical system. You should not get this warning thereafter.

Regards

Bhavesh

[Former Member]

Hi Bhavesh,

i have added the SWCV for SAP ECC to the respective technical system but I receive again the notification. Additional I am not able to select the message typ INTERNAL_ORDER for set path to needed element. No message will appear.

Any idea?

Regards,

Jochen

[Former Member]

Did you save the message type?

regards

krishna

[Former Member]

Hi Krishna,

the message type "INTERNAL_ORDER.INTERNAL_ORDER01" exist under Software Componenten Version\Imported Objects\IDocs at IR and is activated.

Regards,

Jochen

[Former Member]

Hi

When you pop up a dialog box to pick the message type,

Are you trying to select the IDOC under the Message Type tree??

You should rather select it from the Imported objects? Do you see the IDOC under the Imported Objects tree?

regards

krishna

Message was edited by:

Krishnamoorthy Ramakrishnan

[Former Member]

Hi Krishna,

this is exactly my problem but i have filled the path manually and it seems to be it works.

So perhaps it is a bug?!

Many thanks for support Krishna!

Regards,

Jochen

Message was edited by:

Jochen Schertel

[henrique_pinto]

> Hi Krishna,

>

> the message type "INTERNAL_ORDER.INTERNAL_ORDER01"

> exist under Software Componenten Version\Imported

> Objects\IDocs at IR and is activated.

>

> Regards,

>

> Jochen

Under which SWCV it exists in IR?

As pointed by Bhavesh, you have to add the product that contains this SWCV to Technical System which contains the Business System you're trying to use that interface with. It's done in SLD.

When you select the product, make sure you mark the proper SWCV in the left panel, then save it. It'll be added to that Technical System. But you still need to go into the specific Business System and select that SWCV, in order to properly associate it to the BS.

In the future, as a project best practice, make sure you follow these steps b4 starting IR/ID development.

1. define your project SLD (Technical/Business Systems);

2. create/import the Products/SWCVs you're going to work with;

3. associate the Products/SWCVs to the relevant Technical/Business Systems in SLD.

Regards,

Henrique.

[bhavesh_kantilal]

Hi,

This basically implies that the Business System you are using as the Sender Service, is not associate with the SWCV in the SLD.

This is just a warning. You can ignore this.

Regards

Bhavesh