Skip to Content
avatar image
Former Member

HANA Tables Vs Tables created in SE11 as Column storage

Hello All..

As we know, we can create a Table in SE11 as column storage and it would be visible in HANA Studio as well. But while created a Table in HANA Studio it's not visible in SE11.

So My 1st Question is what the reason behind that.

Question 2: if we can create a Table in SE11 as column storage then why an ABAPer would create a HANA Table in HANA Studio.

This might be extended to CDS as well.

Thanks,
Sanket Sethi

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Jul 04, 2017 at 11:12 AM

    Hi Sanket,

    Tables in HANA can be created via SQL command, HANA studio and SE11 (application end).

    For Q1. This should not happen that the table created in studio is not visible in SE11. Did you create the table in right schema?

    For Q2. There is not need to create the table again in HANA studio

    Regards,

    Prithviraj

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      That's fine but as I assume there might be some limitations while we create Tables from SE11 instead of HANA Studio. And I am looking for those points, as I can't found the same in SDN sites.