Skip to Content
avatar image
Former Member

Release Order Network to Time Series

Hi,

I'm using /sapapo/lcout to get the sales order from Order liveCache (OLC) to DP Time Series. The copy/release happens successfully, however when I go to the Planning Book, I don't see any values.

I've adjusted the time series after the release....

Any ideas? why I'm not seeing the data in the PB?

Thanks

Suren

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    May 16, 2007 at 07:36 AM

    do you have a log setup for your release to DP. Does this give any details?

    also pl Check the CVC in DP planning area and see if it matches the Characterisitcs you try to release to DP. You need to make sure the extended part of the program has the characterisitcs selected

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 16, 2007 at 08:04 AM

    Hi Harish,

    Yes the log is setup, the log reads as line1 - "Release - Key Figure Copy Sales" its green and "Characteristic combination prod/location" its green too!

    The CVC exists for that combination of prod/location and the extended one is selected for the product/location characteristics

    Thanks

    Suren

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member

      does your DP planing are contain 9AMATNR and 9ALOCNO or some other characterisitics

      the extended section is supposed to take care of the translation

      Another way of checking is to see if the Release of DP to SNP works.

      also not sure if this will work, but check this out too... i dont think you need to do this since the extended section is supposed to take care of it

      in the maintainance of the MPOS (and planning area) choose the DP MPOS and choose edit-->assign location/product and mark the DP characteristics that correspond