Skip to Content
avatar image
Former Member

Design/Configure Scenario using RWB->Test Message and BPM

Hi everybody,

I would like to set up a scenarion using a synchronous http-request.

The request should be routet to a BPM and a response message should be posted back to the HTTP.

How can I achieve this?

Thanks

Regards Mario

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

5 Answers

  • avatar image
    Former Member
    May 14, 2007 at 02:03 PM

    Hi MArio,

    Following are steps for your requirement

    Receive step open s/a bridge

    Transformation Interface mapping between Async message of receive step and

    async message of Sync send step

    Sync Send step send request to HTTP

    Transformation map the async respose from sync send step and async response

    message from receive step,

    Close s/a bridge async message from receive step.

    Thanks,

    Tuhin

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Bhavesh Kantilal

      Hi Bhavesh,

      after setting the parameter I saw the message in SXMB_MONI.

      Greeting to india!

      What's the time there?

      Here it is 6:00 pm

      Regards Mario

  • May 14, 2007 at 01:16 PM

    Mario,

    You use the Synch Asynch Birdge for that.

    Check the Pattern Synch - Asynch on Help .sap and also on the patterns in the SAP Basis component in your IR

    Also look into the blogs on SDN that discuss "Synch - Asynch Bridge".

    Regards

    Bhavesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 18, 2007 at 09:36 AM

    Hi Mario,

    Could you please clear the requirement, because you are sending the synchronous http-request and

    <i>The request should be routet to a BPM and a response message should be posted back to the HTTP.</i>

    It means, are you getting any msg which is used as response in BPM..?

    see whatever we are sending the message to BPM , that will be available , but response ??

    if you use any transformation step which will transform the sender msg into another strucuture and getting that msg as response back to http response

    this may be possible..

    Is this you want or some thing other??

    Regards

    Chilla

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 18, 2007 at 04:01 PM

    Thank you all!

    Have a nice weekend!

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Nov 11, 2009 at 08:47 AM

    Hi all ,

    I am also getting the same error "The process does not support the given synchronous interface or does not support synchronous messages".

    I am using sync/ Asynsc bridge.

    my interface requirement is : from web service(sync call) i am getting folder creation request once I receive message I need to send the response back to weservice.

    I used BPM Sync/Async bridge. Steps ore Sync-Receive, Async-Send ,Transform and finally Sync send to close bridge.

    Please help me where I went wrong.

    Regards,

    Venkat Tirumalasetti

    Edited by: Venkat Tirumalasetti on Nov 11, 2009 9:48 AM

    Add comment
    10|10000 characters needed characters exceeded