Skip to Content

Issues while replicating table in hana via slt after changing transformation structure

Hi ,

I removed some of the field in transformation in SLT for a table.And replicated successfully.After that I am changing in transformation again and adding some of the removed field. And ch automatically brings new metadata and data.Seems it does not do it automatically.

Then I tried to replicate new structure which comes like Logging table:- 1/CADMC/00000251' for the same table but it is failing with the below error.

Error when reading the DDIC-data for table /1LT/00000000284 (RFC destination NONE) Message no. DMCLG248 Diagnosis The attempt to read the structure of a table from the data dictionary of the sender or receiver system failed. An error occurred. Procedure Do the following checks: Does the rfc destionation exist, and is it correct (SM59)? Can you log in to the remote system? Does the specified table exist in the remote SAP system? If the problem occurred in the context of TDMS, the corresponding conversion object is most probably obsolete. Proceed as described in OSS note 888516. Structure relationship error: receiver structure R_MKPF does not exist.

Can someone help. My concern is if I load my table today with 4 fields what if I need to add new more fields in future?Whats are the steps needs to be done?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Aug 08, 2017 at 05:01 PM

    Hi Priyanka,

    Did you try reloading the entire table after the transformations were done. In my case i had to delete the table and reload it again.

    i think changing the structure of any table in LTRS will need a reload.



    Add comment
    10|10000 characters needed characters exceeded