Skip to Content
avatar image
Former Member

Mapping target fields

Is there a way in the we can map two target fields to each other. In this case using an idoc wherein the requirement is that two target fields need to mapped to each other to produce the final output. Is this possible using graphical mapping.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • May 08, 2007 at 06:58 AM

    <i>Is there a way in the we can map two target fields to each other. In this case using an idoc wherein the requirement is that two target fields need to mapped to each other to produce the final output. Is this possible using graphical mapping.</i>

    >>>>

    is there any source field linked to these target fields ? what will be the value that will be populated in these fields ?

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 08, 2007 at 07:26 AM

    Hi Pradip,

    U can achieve the requirement by using an Interim map...

    In the Interface Mapping use two maps:

    Source --> Destination

    Destination --> Destination (Apply the required logic in this Interim Map)

    Regards

    Pravesh

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 08, 2007 at 07:19 AM

    Hi,

    You want to map two target fields to each other .

    see among these two fields one field should be mapped to one source field is it correct , other wise how it is getting the value from the source field , if it is existed then map with that field to the second field with Copyvalue or useOneAsMany standard functions.

    Or map with Constants.

    Regards

    Chilla

    Add comment
    10|10000 characters needed characters exceeded