cancel
Showing results for 
Search instead for 
Did you mean: 

SAP Audit Log...

Former Member
0 Kudos

Hi Experts,

I have configured Security Audit Log with following paramaters

1)DIR_AUDIT

2)FN_AUDIT

3)rsau/enable

4) rsau/max_diskspace/local

5)rsau/max_diskspace/per_day

6)rsau/max_diskspace/per_file

7)rsau/selection_slots

After set all these parameters i have restart SAP Instance and it is working fine but when i am analyzing the logs getting two suspects logs i am getting which i cant able to make it.

The Logs are

1) AUDIT: Slot 2 Inactive

2) AUDIT: Slot 3 Inactive

Please help me out whether problem is in the parameter setting or this is any other things.

Thnaks & Regards

Krushna Biswal

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

Hi Krushna,

you need to specify the number of slots in rsau/selection_slots. Based on your release there is a maximum number possible. We have ECC 5.0 and can have up to 10 but this was lower in earlier releases.

Please reward points if useful.

Kind regards

Petra

Former Member
0 Kudos

Hi Petra,

Thanks for the update. We are using here SAP R/3 4.7, Ext. Set 1.10. So could you please tell me what is value, i need to set for the parameter rsau/selection_slots.

Thanks & Regards,

Krushna

Former Member
0 Kudos

Hi Krushna,

here's an extract from Note 539404:

<i>[4] Question: How many different selections can I make?

Answer: Unfortunately, the documentation for the parameter rsau/selection_slots is incorrect in some releases. Here are the current values:

4.0 4 (with screen enhancement) (Note 107417)

4.5 4

4.6 10

6.10 10

6.20 10

6.40 10</i>

So I guess for your release (it should have one of the 6.* Basis releases) 10 is the maximum number of slots. But it is your decision what value you put in. With your error message I assume you need to at least put in 3 as you have defined 3 filters. We've put in the max of 10 but have not maintained/activated all filters at all times.

<b>NOTE:</b> <i>When entering values higher than 5, the RZ10 displays a warning stating that the parameter value is not valid.</i> <i>This warning can be ignored.</i> We've experienced that in 4.6 - not sure if it is the same in higher releases.

Please reward points if this helped.

Kind regards

Petra

Former Member
0 Kudos

Hi Petra,

The notes are really helpful. Thanks for the update.

Thanks & Regards,

Krushna Biswal

Former Member
0 Kudos

Hi Petra,

Could you please help me out activate the Security Log, I am having some doubts what all are the profiles i need for this.

Thanks & Regards,

Krushna

Former Member
0 Kudos

Hi Petra,

In my previous message, instead of System Log, i wrote security log.

Answers (0)