Skip to Content
avatar image
Former Member

SXMB_MONI: Outbound Status Red (Need Err Message Alerts)

What is the best way to setup meaasge alerts in XI for a red flag in SXMB_MONI in the "Outbound Status" field? We currently have error messageing setup in ALERTCATDEF that will send an error message when the "Status" field is a red flag but I don't know if there is a way to point it to the "Outbound Status" also. We use the following short text in ALERTCATDEF for notification:

System: &SXMS_ERRSRC_SYSNAME&

POS XI Message ID: &SXMS_MSG_GUID&

POS XI Error Category: &SXMS_ERROR_CAT&

POS XI Error Code: &SXMS_ERROR_CODE&

I am thinking tha ALERTCATDEF will only send an alert when the "Status" field is red flag, and may not be possible to point to the "Outbound Status" field".

Any suggestions? Thank-You.

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Apr 13, 2007 at 02:27 PM

    HI,

    Oubound side is red ...?

    Did you tried this type method.

    Alerts with variables from the messages payload (XI) - UPDATED - /people/michal.krawczyk2/blog/2005/03/13/alerts-with-variables-from-the-messages-payload-xi--updated

    Regards

    Chilla

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Apr 13, 2007 at 02:28 PM

    Hi,

    There might be some configuration you can make.

    In RWB, go to Alert Configuration.

    In Alert Configuration, under "Where did the error occur?", select Integration Engine. For the Error Category, choose XIServer. Then, in the dropdown for Error Code, you can see a couple errors related to "Outbound".

    If you cannot find anything suitable there, you can check out other Error Categories.

    Regards,

    Bill

    Add comment
    10|10000 characters needed characters exceeded

    • Hi,

      You can actually restart message with an Error on the outbound side.

      If it is an Idoc, then go to SM58 and restart the TRFC from there ( there is report for this - Check Naveen's blog --> How to restart messsages automatically in XI )

      If BPM, then correct the error and then restart the workflow of your BPM.

      Yes, but you dont get alerts for TRFC errrors ( SM58) errors.

      Regards

      Bhavesh