Sending Alerts using CCMS

[Former Member]

Hi ,

I have a scenario like FILE->XI->R3 ..We have inbound proxy in R3 to process and we are raising some exceptions if any error occurs..We have also scheduled a Background job to reprocess the errored messages..

So the job considers these exception messages as errored one and reprocessing and the result is we are not able to see the error message..

Is it possible to capture these error messages and send mails using CCMS

Note :-

1.Is there any way to ignore Exception raised message in RSXMB_RESTART_MESSAGES for not to process..Dont suggest me copy and do the changes in that pgm.

[Former Member]

Hi,

Please chk these blog..it's might help u..

<b>/people/michal.krawczyk2/blog/2005/09/09/xi-alerts--step-by-step

<b>/people/michal.krawczyk2/blog/2005/09/09/xi-alerts--troubleshooting-guide

<b>/people/michal.krawczyk2/blog/2005/03/13/alerts-with-variables-from-the-messages-payload-xi--updated

<b>http://help.sap.com/saphelp_nw04/helpdata/en/56/d5b54020c6792ae10000000a155106/content.htm</b>

Cheers!

Samarjit

[bhavesh_kantilal]

Hi,

check these blogs and check if they help,

<a href="/people/aravindh.prasanna/blog/2005/12/23/configuring-scenario-specific-e-mail-alerts-in-xi-ccms-part--1">Configuring scenario specific E-mail alerts in XI-CCMS: Part - 1</a>

<a href="/people/aravindh.prasanna/blog/2005/12/24/configuring-scenario-specific-e-mail-alerts-in-xi-ccms-part-2">Configuring scenario specific E-mail alerts in XI-CCMS: Part-2</a>

<a href="/people/aravindh.prasanna/blog/2006/02/20/configuring-scenario-specific-e-mail-alerts-in-xi-ccms-part-3">Configuring scenario specific E-mail alerts in XI-CCMS: Part 3</a>

Regards

Bhavesh

[Former Member]

Hi Bhavesh,

I had tried already what u suggested..my requirement is to catch those exceptions and send as a alert ..

Regards

Anandan

[Former Member]

Hi,

In R3 side what type of interface you are using ?? isit IDoc or RFC ?

If it is RFC , then does it contain the exception tab - i mean exception handling in that RFC , then you would have to map the fault message mapping and in that you can MM , try to raise an alert ,

Or try to use this interface by sending as an atachment to mail .. so far i have not tried , for this ..

Regards

Chilla