No data Available in source system

[Former Member]

Hi ,

Iam getting an error while loading the data into infocube.

I checked my data source in RSA3. it has 26 records. but those records are not coming into infocube.

Kindly help me on this issue.

Regards

Aravinda

[shanthi_bhaskar]

hi aravinda,

try to replicate the datasource once again.

then check it out.

regards

bhaskar

[Former Member]

Hi Arvinda,

Check "Data selection tab page " nothing is restricted. ..

Also try loading Full update and it should fetch you some record, that will make sure that there is no error in extractor side .

Hope that helps.

Regards

Kapadia

***Assigning points is the way to say thanks in SDN.***

[Former Member]

Hi,

Still i am getting the same problem .

kindly help out on this issue.

regards

Aravinda

[Former Member]

Hi Arvinda,

Paste the error message to move forward.

Hope that helps.

Regards

Kapadia

***Assigning points is the way to say thanks in SDN.***

[Former Member]

this below message i am getting

No data available

Diagnosis

The data request was a full update.

In this case, the corresponding table in the source system does not

contain any data.

System Response

Info IDoc received with status 8.

Procedure

Check the data basis in the source system.

[Former Member]

Hi Arvinda,

Check the authorization for background user ( For user name refer to view RSADMINCV3 ) in SAP R/3 system . Could be issue with Authorization , also check for abap dump in transaction code st22 at r/3 side.

Hope that helps.

Regards

Kapadia

***Assigning points is the way to say thanks in SDN.***

[Former Member]

Hi,

there is no issue with autorization and ia m not geting any short dumps in r/3 side so far.

In RSA3 my data source has 26 records but in BW side no records

plz advice

Regards

Aravinda