Skip to Content
0

Configure 1 Delivery to 1 stage in a shipment with Freight cost breakup as per delivery item

Jun 12, 2017 at 07:42 AM

110

avatar image

Dear Gurus,

I need some help I need to configure 1 delivery to 1 stage in a shipment document at the same time showing proper freight cost breakup for each delivery item. (1 Vehicle = 1 Item in a delivery) also Route is the same for all in this example.

Example,

1st Delivery my ship to party is dealer A in Chicago (Route)

2nd Delivery my ship to party is dealer B in Chicago (Route)

3rd Delivery my ship to party is dealer C in Chicago (Route)

4th Delivery my ship to party is dealer C in Chicago (Route)

(Selection criteria of cond. record is Route & Ship to Party)

Condition record in case of 1 is $10

Condition record in case of 2 is $12

Condition record in case of 3 is $15

Condition record in case of 4 is $15

So total of my shipment document will be $52.

Right now my config setup displays the following. In main leg it shows all the deliveries and shows the total value which is fine I guess but then on the 2nd line item which comes automatically as subsequent leg it shows only 2 deliveries of the same dealer. At the end the cost is adding both lines of main leg and Subsequent Leg. Which if using calculations from above would be $52 +$15 + $15= $82 and not $52

condition.png

ox1am.png (98.4 kB)
actgn.png (87.1 kB)
6ktrn.png (113.5 kB)
condition.png (109.2 kB)
10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Kivanc Bilgin Jun 20, 2017 at 07:23 AM
1

Check your shipment cost relevance from customizing of Shipment cost document -> Shipment Cost Relevance


Show 3 Share
10 |10000 characters needed characters left characters exceeded

It's configured or checked at Header and Leg. If this was not setup no price would show but it does show a price in my case. Thx.

0

Why is your subsequent leg relevant for shipment costing then (As all deliveries are already assigned to the main leg)?

0

I guess the question is then why are they coming as subsequent legs as well if its already mentioned in the main leg. Even with checking off Subsequent Leg for costing I get the wrong Tender on main leg.

I'm getting a value of 72,000 where as it should be 37,000

Update: I played around with a few settings in config now i'm getting the correct 37,000. I would like to figure out why the subsequent legs are coming though as a stage. Technically speaking the subsequent leg is a different ship to party.

0