I am using this condition record in Pricing procedure in PO where there is no access sequence attached. Also it was not maintained manually by me. Not sure from where PO pricing is pulling the value. In analysis screen for Pricing procedure(in conditions tab in PO) I see below message assigned to this condition. Message 207 : Condition has been found (without condition record) I have seen a lot of threads were same query has been raised but no one has answered. Everyone is asking to check access sequence and if it was entered manual. Trust me I know basic logic of how conditions are pulled in pricing procedure. If anyone has found the reason kindly share the same. I sense it could be the adopt data from past PO setting but still no concrete reason found yet.