Dynamic Filter routine in DTP

[dirk_meyer2]

Hi there.

I am facing a strange encounter with a Filter routine for a DTP where define the filter based an a hierarchy node.

Ther routine I tested and works fine, BUT as it turns out now only if teh DTP is set on Delta mode. As soon as I reset it to Full or copy it and select Full the values the routine delivers will be ignored.

I say ignored because in debugging the table l_t_range is filled properly.
Though the Log Header if the Request does not show the values and nothing gets filtered.

As soon as I switch back to delta everything works fine again.

Any clues from some one?

Thanks for help

Dirk

[dirk_meyer2]

Closed

That seemed to be an activation error.